CM-X255 Credit Card sized System on a Module

CompuLab introduced the CM-X255 - the third generation of the popular ARMCORE SOM (System-on-Module) originally presented to the market one year ago. The new GX version brings several major improvements: better graphics performance, cost-efficient Ethernet, touch screen controller and improved compatibility with CAMI mechanical specs. These further extend the product's capability to address an even wider range of applications. The CM-X255 comprises an Intel PXA255 CPU up to 400 MHz with an integrated graphics controller, SDRAM, Flash Disk, PCMCIA interface, 100Mb Ethernet, USB, sound, touch screen controller, serial ports, infrared interface, general purpose I/O, real-time clock, PS/2 keyboard and mouse controller, parallel port, and interfaces to floppy and hard disks. Many of the above-mentioned features are optional and are included according to the application's requirements. The CM-X255 provides a local bus as well as PCI and LPC buses for interface to off-board expansions. The module is designed for mezzanine attachment to a custom baseboard via two miniature 140-pin connectors

DM6952HR PC/104 Relay Output Board

The DM6952HR dataModule® combines on one board 16 power relay outputs. These relays may be used to reliably switch voltages from 5V DC to mains voltages of 230VAC. The onboard relays have two identical pairs of contacts. These contacts are connected on parallel. Both Normally Open (NO) and Normally Closed (NC) contacts are available on the I/O connectors. Use this board in applications such as AC or DC power circuit breaking, motor and actuator control or voltage level shifting.

The outputs of the DM6952HR are inactive after reset and will maintain their state even if the system is reset from software. This will prevent uncontrolled output operation in cases of system failure.

PCI RS-232, RS-422, RS-485, RS-530, RS-530A, V.35 Synchronous Serial Interface

BU 66318 ACE MIL-STD-1553 PCI Bridge

The BU-66318 ACE-Bridge provides a simple, complete and tested solution for interfacing any of DDC's ACE series (including the ACE, Mini-ACE™, Enhanced Mini-ACE, Micro-ACE and Mini-ACE Mark3 series) MIL-STD-1553 terminals to a PCI bus.

The ACE-Bridge connects directly to any 3.3 volt PCI bus as a Target device. With its interrupt support and a 32 deep by 32-bit wide FIFO allowing for burst write transfers, the BU-66318 can significantly reduce system overhead by utilizing the efficiency of the PCI bus.

The BU-66318 may be connected to up to six ACE series MIL-STD- 1553 terminals directly without any "glue logic."

Utilizing a SELECT and STROBE handshake method, the BU-66318 accesses all of its MIL-STD-1553 terminals RAM and Registers through a 16 bit Address / Data bus.

Support for an optional local microprocessor is included in the ACEBridge. If a local microprocessor is added, the BU-66318 uses a DMA type handshake method to arbitrate for the local bus. A shared RAM interface is also included

Model 4101 Ethernet to Serial Converter

The 4101 Ethernet to serial server is the easiest way to connect RS-232 serial devices to your Ethernet network. The 4101 uses industry standard TCP/IP protocol which allows any host to access the serial port as a virtual COM port as easily as if the port was physically installed in the host. The Sealevel SeaLINK.232 (Item number 4101) is a single channel RS-232 Ethernet based serial I/O adapter supporting data rates up to 230.4K bps. The RS-232 compatibility allows for connection to devices utilizing the RS-232 electrical interface, such as modems, data-entry terminals, and plotters.

CME 36786 series PC/104 cpuModule™ with Advanced Digital I/O

The CME 36786 series of CPU PC/104 single board computers (SBC) use the VIA Eden CPU with a mini fan heatsink. The CPU can be provided in 400, 733 and 1 G Hz clock speeds and the module can be loaded with up to 512 M Dram. All units are rated over the industrial temperature range of –45 to + 85 degrees C as standard. Other features of the card include 2 serial RS 232/422/485 ports, 2 USB ports, a 10/100 Ethernet port, on board SVGA controller and integrated TFT Flat Panel support, 18 DIO and AC97 Audio. The CME 36786 series can also be supplied in the IDAN PC/104 mounting system for fanless operation

TravelStor 5S Lightweight RAID Storage

Allied Data Systems Pty Limited announces the release of the TravelStor 5S. The TravelStor 5S is a lightweight RAID storage solution, designed with portability in mind and/or for very small businesses that do not need many features or a large storage capacity. The TravelStor 5S provides an Ultra160 SCSI interface with standard HD68 connection to the host computer for fast direct attached storage. Key features include:

• ( 5) Hard disk drive bays, capacity up-to 1.25 TB. IDE/ATA disk drives. All drive bays are hot-swappable
• RAID 0, 0+1, 1, 3 or 5. JBOD and NRAID supported
• RAID 5 dynamic expansion on-line for adding capacity at a later date
• Front-mounted LCD keypad for quick configuration changes or event monitoring
• RAID management performed via standard web browser for ease of use
• Each drive bay has activity and fault LED’s for event monitoring or troubleshooting
• 150 watt power supply
• 200 MHz RISC processor
• 64 MB ECC cache memory
• Lightweight, user-friendly interface and designed with portability in mind. 12 lbs without disk drives, under 20 lbs fully populated